We were convinced that people would want to rent arcade games by the month, but truth be told, we had no idea how to operate on them. Before we knew that our launching was a month off and we had managed to accumulate about 100 matches, but only 10 of them worked!
We understood enough to refurbish a good chunk of those matches, but we kept hitting the same symptom over and over again. All of our monitors would exhibit a scrambled image on the screen. It was super frustrating because we had no clue how to repair it. We almost missed our launch, but we finally clued in on what exactly was causing our probablem when we learned about monitor sync 101 and recognized that they sometimes need to get hooked up differently depending on the game. On that day, we must have turned on at least 20 games, that we had put a lot of hard work into, but had been missing this last piece of the puzzle in order to have the ability to play them. This tiny chunk of understanding, gave us the games we all needed to begin and was sufficient to keep us motivated to keep learning how to fix problems.
Five years later, I spend more time researching arcade fix, I ever spent studying in school and the instruction continues to pay off.
For the previous few years, we have experienced an average bug that's crept into our fleet.
To fix the symptom, we would boost the power source to operate hot which would be good for another 3 to six weeks until the electricity supplies would burn . After running into this puzzle a couple of times, we began to put the matches into deep storage until we could find out why they kept failing. Because we presumed, it had been caused by poor circuit boards hoping to draw too much energy, we overlooked something a lot more obvious.
After cleaning the chips, it might sometimes help, but this insect has managed to brick at 20 of our matches. Well todayour Mortal Kombat 2 started to exhibit exactly the same symptoms and quite honestly if we pull this one by the fleet, our customers will riot, so that I sat down to get into the root of the event of the fall in voltage.
To achieve this I took my voltage meter, then measured the power at the power source and then began spreading the 5V line and measuring wherever I could touch cable. When I measured the power before it even went into the edge connector, I saw the voltage had dropped. I suspected the connector between the wire and the power source. The moment I crimped over the end of the line to put to a new one, I instantly noticed exactly what my problem was.
We love getting a fantastic deal and I would be happy to bet you a quarter, which you can't find a better bargain on the jamma harnesses that we buy. Unfortunately, it looks like we might have gotten exactly what we paid for them.
That's a whole lot of metal to run a small quantity of voltage. It is part of why I never suspected it was our culprit.
Once you start this up however, it is possible to see that from the outside it looks 18 gauge, but on the inside it is short quite a bit of metal. The solution was easy, run a thicker wire from the power source to the harness and Voila!
While this easy bug should have been spotted sooner and has caused us a lot of headaches, it is also incredibly exciting to figure out the source of our difficulty and to understand that with very little work, we have another 20 amazing matches back on our website. Learning how to correct arcade games hasn't been simple and your schooling never ends, but every time you solve a puzzle, the next vr game (https://www.childwelfaresocietykenya.org) gets easier and easier to repair.
Hopefully, other people who have run into similar trouble, can save the exact same aggravation by A.) double checking the wire you're using when you can not get your voltage to travel cleanly from your power source to your circuit boards and B.) paying only slightly more better quality jamma harnesses.